In the VW 80000 standard developed by Volkswagen automobile company, general requirements and test conditions for electrical and electronic components in motor vehicles up to 3,5 tons are explained and test methods are defined. This standard applies to electrical, electronic and mechatronic components and systems for use in motor vehicles up to 3,5 tons.
The VW 80000 standard is based on a template drawn up by representatives of the automobile companies Audi, BMW, Daimler, Porsche and Volkswagen.
These tests include multiple testing processes that include initial sample inspection and functional checks, electrical and electromagnetic compatibility (EMC) tests, environmental testing, corrosion, vibration and other mechanical testing. A few tests performed within this framework are: long-term overvoltage, transient overvoltage, fast start, load unloading, superimposed alternating voltage, slow supply voltage decrease and increase, slow decrease in supply voltage, rapid increase, reset behavior, short interruptions, pickup pulses, intelligent generator controlled voltage curve, pin interruption, connector interruption, reverse polarity, ground offset, short-circuit in signal circuit and load circuits, insulation resistance, closed-circuit current, dielectric strength, feedbacks, overcurrents.
The mechanical tests defined in this standard are: free fall, stone impact test, dust test, vibration test, mechanical shock and endurance shock test.
The climate tests defined in this standard are: high / low temperature storage, incremental temperature test, low temperature operation, repaint temperature, temperature shock (component), operational salt spray test, outdoor, operational salt spray test, indoor, humid heat, cyclic, moist heat, cyclic (frosty), water protection, IPX0 and IPX6K 99, high pressure cleaning, splash water temperature shock, temperature shock, immersion, moist heat, constant, condensation and climate test, temperature shock (bodyless), solar radiation and harmful gas testing.
The service life tests defined in this standard are: mechanical / hydraulic endurance test, high temperature endurance test and temperature cycle test.
The VW 80000 standard describes requirements for electrical, electronic and mechatronic components and systems for use in motor vehicles with a 12 Volt electrical system. Unless otherwise stated, these tests are not electrical service life tests. Additional or deviating requirements, test conditions and tests are defined in the relevant component performance specifications. The tests presented are used to check some of the required properties of the component, but not to qualify parts or qualify the manufacturing process.
Our organization, among the numerous test, measurement, analysis and evaluation studies it has given for businesses in various sectors, with its trained and expert staff and advanced technological equipment, within the scope of VW 80000 standard, general requirements and test for electrical and electronic components in motor vehicles up to 3,5 tons. It also provides testing services in accordance with the conditions.
To get an appointment, to get more detailed information or to request an evaluation, you can ask us to fill in our form and reach you.
